This is a Santa Claus made with four 7.5cm×7.5cm origami and glue. The nose and the belt are added as the final touch. Fold about 7mm. Fold about 2mm. Fold up using the folded lines from before. Fold the left and right side into the center. Use the tips of your finger to fold it open just a little. It’s like this. Fold the other side in the same way. The first part is done. Fold it about the same height as the skin colored section. The bottom point is 5 mm away from the center. Fold the other side in the same way. The second part is done. Fold the corner to the center. Fold the other corner in the same way. Open it using the folded line. Make the hand by folding back the corner. It’s easier to fold if you just open the corner. Fold the other side in the same way. Fold where the black line indicates to make the toes. The third part is done. Fold it to overlap the 2 points. The fourth part is done. Let’s put together using glue. Align the folded center lines on the 2 sheets. Fold back the part that is sticking out. Put together using glue. Overlaps these 2 points so that the arm can be seen. Fold it along this line while it’s still overlapped. Fold up using the folded lines from before. Glue it here after overlapping it like before. Glue this arm part too. Glue together the Santa Claus and the bag. Draw Santa ‘s eyes and add a nose and a belt. The nose is paper cut into a circle. You can draw the belt on with a pen too. Thank you for watching! See you next time!